Application of oxyhydrogen flame cutting technology on large stainless steel slab
Oxyhydrogen flame cutting, steel rolling
The temperature of the hydrogen and oxygen flame is the best cutting state, and the upper cut surface will not form a molten edge, and the section is smooth and straight; there is no carbon element in the hydrogen and oxygen, the cutting slag is small and loose, easy to clean, and will not form sticky slag. Condensation is at the lower end of the cutting section. After hydrogen and oxygen cutting is used in a steel plant project, there is no major repair for deburring within three years, and the annual consumption of the burr machine fly hammer is reduced by more than half, while avoiding scarring in steel rolling and increasing the yield rate.